Knowledge
PCB cleaning process
Cleaning
- Cleaning agents: various alkaline cleaning agents are available.
Please ask us for advice. - Cleaning principle: spray technology
- Cleaning effect: very good, because
- flux residues are completely removed.
- the solder joints and components are not attacked.
- the cleaning agent is completely removed again after the cleaning process.
- the cleanliness level according to MIL-STD-2000 is exceeded by a factor of 3-4.
- The following are removed without residue:
- rosin-based fluxes
- low-residue fluxes (no-clean)
- water-soluble fluxes
- The specially developed cleaning agents are mild and biodegradable.
See the cleaning quality of our machines for yourself. We will be happy to invite you to a demonstration at our premises, or send us some assemblies for a trial wash.
Drying
- Principle: circulating air drying.
- Air inlet temperature into the machine interior: max. 100 °C
- Interior temperature: max. 85°C
- Duration of hot air drying: 0.1…6 h, recommended approx. 1 h
Sequence of a cleaning process
- Open the front flap of the Öko.
- Slide the wash racks loaded with assemblies into the wash chamber.
- Dose the cleaning agent.
- Close the front flap of the Öko.
- Switch on the machine.
- Select the programme and start the machine. The machine starts working and the programme sequence is shown on the display. After the cleaning process is complete, an acoustic completion signal sounds.
- After 1.5…2 h, remove the cleaned and dried assemblies. The working time required for this is max. 5 min.
Technical information
The water is heated in a continuous-flow heater, so there is no obstructive heating element in the interior.
Thanks to the water protection system and the floor pan, water leakage is practically impossible.
This ensures a high level of protection against water damage. Particularly quiet operation is achieved by consistent 6-sided all-round insulation.
Cleanliness monitoring Öko 2000
To monitor the purity of the final rinse water, its conductivity is measured in the machine and shown on the display.
If the adjustable limit value is exceeded, the programme sequence is interrupted and an alarm is triggered.
